Because our price on this item is lower than the manufacturer's
suggested retail price , the manufacturer does not allow us to show
you our price until you place the item in your shopping cart.
Adding this item won't require you to purchase the product. You
can easily remove the product from your cart if you decide not to buy it.
Power Dissipation: R 60mW, G 95mW, B 95mW
Peak Forward Current (0,1ms Pulse Width): 100 mA for each colour
continous forward current: 25 mA for each LED
max. reverse voltage: 5 V
operating temperature: -40 °C to 80 °C
dimensions: 28 x 15 x 5 mm
Common: Cathode (-)
Attention: Current has to be limited by using resistors.
Voltage: 5 VDC
connection: 3 pin: GND, VCC and OUT
adjustments: sensitivity and delay (by trimmer)
delay time: 0.3 to 18 s
output level: high = 3 V, Low = 0 V
max. sensor distance: 7 m
operating temperature: -15 to +70°C
detection angle: 120 °
dimensions: 32 x 24 x 25 mm
manages all timekeeping functions: real-time clock counts seconds, minutes, hours, date of the month, month, day of the week, and year with leap year
31 x 8 battery-backed general-purpose RAM
Simple Serial Port Interfaces to most Microcontrollers: Simple 3-Wire Interface
TTL compatible: VCC = 5 V
single-byte or multiple-byte (burst mode) data transfer for read or write of clock or RAM data
low power operation extends battery backup run time: 2.0 V to 5.5 V full operation
uses less than 300 nA at 2.0 V
temperature range: 0°C to +70°C
The pinout is designed to work with Arduino and compatible boards that do not have a built-in USB-to-serial converter, such as the Pro and Pro Mini.
The pin VCC can be easily configured to be 3.3 or 5 V by placement of a jumper
This allows the board to be used with boards that operate on either 3.3 or 5 V nominal voltage.
Equipped with USB Mini Connector